MT Logic CL-471MT User Manual download pdf (Page 18)

24. MINUTE BUTTON FOR PROJECTION UNIT

25. HOUR BUTTON FOR PROJECTION UNIT

26. TIME SET BUTTON FOR PROJECTION UNIT

27. FOCUS ADJUSTMENT FOR PROJECTION UNIT

28. PROJECTION ON/OFF BUTTON

29. PROJECTION UNIT

30. AUTO DIMMER SENSOR

POWER CONNECTION

Plug the AC power cord to a household outlet AC source. This unit is

equipped with a battery back up system, it requires a 3 x 3Volt CR2025

Flat Lithium battery (Not included). Insert the battery in the battery

compartment, making certain that the positive and negative (+ and -)

battery terminals are attached to the corresponding terminals on the

plate in the battery compartment. If an AC power failure occurs, the

clock automatically switches to the battery power supply, the clock and

timer memory continue running. When the AC power resumes, the clock

switches back to AC again.

GETTING STARTED

Press the reset button (17) locates on the back of unit after AC plug in.

- The unit will display full segment for 2 seconds, then it will enter the

normal mode.

- Display will lighten up.

1. TIME AND CALENDAR SETTING

A. Setting Time and Calendar – Press Mode Set button (1) in normal

mode and keep depress over 2 second to enter Time Set mode, after

enter the setting mode, press Mode Set button (1) to change the

mode cycle as follows :

CAUTION Make sure the radio isn’t activated, you can check this by turning

the volume knob to the highest position. It’s not possible to adjust the time

when the radio is activated.

Normal g Year g Month g Day g 12/24H g RTC Hour g RTC Min g

Normal

Action (during data adjustment) :

- Press button (7) to adjust data backward

- Press button (8) to adjust data forward

- Keep depress or button for 2 second to enable auto forward

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 56 57

No comments

MT Logic CL-471MT User Manual Page 18